Overview
These are SuperATV’s heavy duty tube rock sliders for the Polaris RZR Trail S 1000. They shield the bodywork along each side from rocks and downed trees, and the bends in the tubing are there to add points of protection, not only for looks.
Which RZR they fit
Polaris RZR Trail S 1000, 2021 and newer, in Premium and Ultimate trim. The smaller engine has its own listing, the tube rock sliders for the RZR Trail S 900, and so does the narrower RZR Trail 900. The older RZR S 1000 is covered by the tube rock sliders for the RZR XP 1000 listing.
Rocks or trees
Think about what actually hits the side of your machine. On rocky trail it is ledges and boulders against the rocker, and that is the job a rock slider is built for. In tight woods it is trunks and stumps, and some riders add tree kickers that reach back toward the rear tire. SuperATV describes these for both big rocks and downed trees, and they sit along the rocker, not out at the rear wheel.
All of our sliders are in UTV rock sliders.
More parts for this machine: Polaris RZR accessories.
Features
- Shape: curved and contoured tubing, which SuperATV says gives extra points of protection against big rocks and downed trees
Tech Specs
| Material | 1.75 inch diameter steel tubing, hand welded |
|---|---|
| Finish | UV resistant powder coat |
| Color | Wrinkle Black, Orange or Red |
| Mounting Type | Bolt on, at the factory mounting points |
Installation
The sliders bolt on at the factory mounting points. Start every bolt by hand before you tighten any of them. Welded tube sliders do not flex into place, so loose bolts all around are what let the last hole line up.
FAQs
Rock sliders or nerf bars?
Same part, two names. SuperATV calls these tube rock sliders and also refers to them as nerf bars.
Which color should I pick?
That is a looks decision. Wrinkle Black, Orange and Red all get the UV resistant powder coat.
Will they fit a RZR Trail S 900?
This set is not listed for it. Use the Trail S 900 listing linked above.
Do I have to drill?
SuperATV describes a bolt on mounting process at the factory mounting points. Nothing in the maker's information calls for drilling.
