Overview
A shovel bouncing around the bed is loud, it beats up your cargo box, and about once a season it goes over the side and you never see it again. This Kemimoto utv tool holder clamps the handle to the cage and keeps it there.
Two install paths cover most machines. You can bolt to a flat surface with a drill, or use the included pipe clamps on any round roll bar from 0.75 to 2.25 inches. That is a wide range on purpose, so it works on a full-size cage and a smaller mid-size bar without buying a different part. Rubber pads at the clamp keep it from sliding on the tube.
The rubber strap adjusts to hold handles from 1 inch to 1.5 inch diameter, which puts shovels, axes, fire extinguishers, and most farm tool handles in range. Kemimoto rates the grips to 15.43 lbs. Material is high-grade rubber, so the strap has enough stretch to snap over a handle and enough grip to hold it through washboard.
- Two install methods: drill to flat surface or clamp to round bar
- Fits 0.75 to 2.25 inch roll bar
- Holds 1 to 1.5 inch tool handles
- Rated to 15.43 lbs
- Non-slip rubber pads at the clamps
Fitment runs to Pioneer 500, 700 and 1000, CFMOTO ZFORCE 500 through 1000, RZR 570, 900 and 1000, RZR PRO XP, Ranger 500 and 570 Full-Size, the Kawasaki Mule series, Maverick X3, Maverick 1000R and Commander, and Gator XUV models. Also works on RV ladders and Jeep round tube.
