Overview
You already own a Bluetooth speaker. This is the cheap, sensible way to get it out of the cup holder and onto the cage where it belongs. The Kemimoto strap mount wraps a roll bar and holds a portable speaker steady through washboard and whoops, no wiring and no tools involved.
It is built from 1680D Oxford cloth with an anti-slip face, and the two-strap layout is the part that matters. A bottom strap sits under the speaker so it cannot slide out the end, while the two-strap arrangement leaves your control buttons exposed instead of covering them the way a single wide band does. Volume and track changes stay reachable without pulling the speaker out of the mount.
The mount fits roll bars from 1.5 to 2.25 inches and holds most portable speakers up to 3.8 inches in diameter and 12 inches in circumference, so measure yours before ordering. That covers a wide spread of machines, including Polaris RZR, Ranger, General and Sportsman, Can-Am Maverick, Defender and Commander, Honda Pioneer and Talon, Kawasaki Mule and Teryx, Yamaha RMAX, Viking and Wolverine, and CFMoto CForce, UForce and ZForce.
- Fits 1.5 to 2.25 inch roll bar tubing
- Holds speakers up to 3.8 inch diameter, 12 inch circumference
- 1680D Oxford cloth with anti-slip surface
- Two-strap design with a bottom retention strap
- No tools needed to install
It is not fussy about what it carries either. A water bottle, an umbrella or a small fire extinguisher all ride in it just as well. The speaker itself is not included.
