Overview
These are SuperATV’s cage light mounting brackets for 1.75 inch tube. They clamp around the roll cage and give you a place to bolt a work light or cube light without drilling the cage.
What it fits
SuperATV says the brackets fit any 1.75 inch diameter roll cage. The fitment chart on this page lists the machines the maker names, with years. In short, it covers Polaris RZR models, older Polaris Ranger models and the Polaris Ace, the Arctic Cat Wildcat and Prowler, the CFMOTO ZForce 800 and ZForce 1000, the Kawasaki Teryx KRX, and the Yamaha Rhino and YXZ.
If your machine is not on the chart, measure the cage tube. A cage that is not 1.75 inch needs a different mount. See the Assault Industries top tube mounts, which come in other cage sizes, or browse UTV light bars.
Front or rear of the cage
Up front, a pair of cube lights on the A-pillars fills in the sides that a light bar misses. On the rear of the cage, the same brackets hold work lights or a reverse light. Decide where the lights go before you route the wiring, since that sets how much wire you need.
More parts for these machines: Polaris RZR accessories and Polaris Ranger accessories.
Features
- Quantity: one pair, which is two mounting clamps and two brackets
- Tube size: 1.75 inch diameter roll cage
- Position: front or rear of the roll cage
Tech Specs
| Finish | Black powder coat |
|---|
Installation
Open the clamp, set it around the tube where you want the light, and tighten it with the supplied hardware. Because it is a clamp, you can slide and rotate it before the final tighten to get the light where you want it.
FAQs
Are lights included?
No. These are the brackets only.
How many do I get?
One pair: two mounting clamps and two brackets.
Will they hold a long light bar?
SuperATV describes them for work lights and cube lights. The maker's information does not mention light bars.
Do I have to drill?
No. They clamp to the tube.
